PV Powered PVP1100 Especificações

Grid Tied Residential Inverter Installation and Operations Manual Models 1100, 2000, 2800, and 3000 Contact Information PV Pow

V97-600002 Page 10 of 31 2.3.3 Grounding A single-point ground connection is located in the lower right-hand side of the inverter cabinet.

V97-600002 Page 11 of 31 2.3.4 GFI Circuit The purpose of the Ground Fault Interrupter (GFI) circuit is to detect a ground fault (unintende

V97-600002 Page 12 of 31 2.3.5 Connecting the Inverter to the Electrical Grid Two circuit boards are located inside the Inverter: • The Co

V97-600002 Page 13 of 31 Figure 6: AC Wiring for the Line 1, Line 2, and Ground Wires WARNING: Before proceeding with the DC wiring,

V97-600002 Page 14 of 31 Inverter Model Maximum inverter start voltage Absolute maximum input voltage PVP1100 450VDC 500VDC PVP2000 450V

V97-600002 Page 15 of 31 WARNING: Do not connect or disconnect the jumper while the inverter is supplied with DC or AC power. 7. Remove th

V97-600002 Page 16 of 31 9. Confirm that the DC disconnect is turned OFF and remove the material from the array. 10. With a voltmeter, ch

V97-600002 Page 17 of 31 3 OPERATION 3.1 Start-Up Procedures for the Inverter WARNING: Before turning ON the inverter, ensure that the fr

V97-600002 Page 18 of 31 3. The inverter’s internal operational parameters, to ensure safe operating conditions exist within the operating

V97-600002 Page 19 of 31 3.2.2.1 Normal Display Cycle The display will change screens every two seconds to show a different set of informat

V97-600002 Page 2 of 31 Table of Contents IMPORTANT SAFETY INSTRUCTIONS ... 4

V97-600002 Page 20 of 31 4.2 Displayed Fault Codes The vacuum fluorescent display (VFD) provides the following codes when a fault has occurr

V97-600002 Page 21 of 31 The above example shows a Power Low fault. After the fault occurrence, the inverter had a DC Voltage High fault.

V97-600002 Page 22 of 31 0100 0000 CPU Fault The inverter encountered a problem in the CPU. This fault requires an AC power cycle to rese

V97-600002 Page 23 of 31 5 SPECIFICATIONS 5.1 Operational Specifications The specifications detailed below are expected operational paramet

V97-600002 Page 24 of 31 5.2 Abnormal Specifications The specifications listed below are classified as abnormal and are not representative o

V97-600002 Page 25 of 31 6 LIMITED WARRANTY PV Powered, Inc. provides a limited warranty for your residential or commercial inverter and op

V97-600002 Page 26 of 31 • Exposure to unsuitable environmental conditions (including but not limited to damage due to lightning strikes, s

V97-600002 Page 27 of 31 RENDERED PURSUANT TO SUCH ARBITRATION SHALL BE BINDING ON THE PARTIES. THE LOCATION FOR ANY ARBITRATION HEARINGS SH

V97-600002 Page 28 of 31 7 RETURN PROCEDURE Before returning the product directly to PV Powered, you must first obtain a Return Materials A

V97-600002 Page 29 of 31

V97-600002 Page 3 of 31 7 RETURN PROCEDURE ... 287.1 Informat

V97-600002 Page 30 of 31

V97-600002 Page 31 of 31

V97-600002 Page 4 of 31 IMPORTANT SAFETY INSTRUCTIONS This product has been engineered and manufactured to ensure your personal safety. Imp

V97-600002 Page 5 of 31 1 INTRODUCTION The PV Powered Grid Tied Residential Inverter is a utility interactive inverter for photovoltaic (PV

V97-600002 Page 6 of 31 2.2.1 Mounting the Inverter 1. Locate the wall studs in the desired location and align the mounting bracket over

V97-600002 Page 7 of 31 Figure 2: Inverter with mounting bracket in place NOTE: Leave the inverter cover off to allow for electrical con

V97-600002 Page 8 of 31 2.3.1 Inverter Voltage and Frequency Limits The inverter is factory-calibrated to the voltage and frequency limits

V97-600002 Page 9 of 31 IMPORTANT: When mounting the inverter outside, use rain-tight or wet-location conduit hubs that comply with the re