PV Powered 5200 Manual descarregar pdf (Página 32)

Communication and Monitoring

Press "OK" twice then will enter "Manual-IP" interface. Press "right" or "left" key to move the cursor

to select the figure which need to be modified. Press "up" or "down" key to modify figure(IP Address：

192.168.000.002. Subnet Mask：255.255.255.000, others are 0). Press “OK” after modifying. LCD will

display the setting parameter and press “OK” again, now setting is over. LCD interface will Reboot and

then enter to home interface automatically.

Parameter set for PC:

Set IP address as 192.168.000.001,

Set Subnet mask as 255.255.255.000.

Ethernet

2012-03-03 10

Press OK to confirm

Auto-IP/DHCP

Manud-IP

Current mode: Manual-IP

Ethernet

2012-03-03 10

Confirm?

Auto-IP/DHCP

Manud-IP

Current mode: Manual-IP

Manual-IP

2012-03-03 10

Press OK to confirm

Up/Down : Increase/Decrease value

Left/Right : Move Selection

IP:

255.255.255.000

000.000.000.000

SubnetMask:

Gateway:

DNS:

192.168.000.002

① Need to install SolarRiver-D inverter monitoring software in the PC when using

WIFI, Ethernet communication.

② Can’t using RS485 and Ethernet communication mode for a PC at the same time.

③ The default set is “Auto IP”. If use router, LAN or WAN monitor is available without

any parameter setting.

④ In WAN mode, must use router and recommend to select auto IP mode.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Sem comentários

PV Powered 5200 Manual Página 32