PV Powered PVP1800 Especificações descarregar pdf (Página 8)

PV Powered LLC 7 11-18-28-704

3. Remove the front cover of the StarInverter by unscrewing the two cover screws

located on the bottom of the inverter. (The PVP2800 will have four cover

screws located on the front and bottom of the inverter.)

4. Attach the lower mounting bracket, being careful not to damage the heat sink

cooling fins. See Figure 5.

Figure 5: Underside of StarInverter and Lower Mounting Bracket

5. Carefully bring the inverter right side up and hang it on the upper bracket.

6. Verify inverter is level. Seal the upper mounting holes on the inverter with

RTV.

7. Mark the locations of the lower mounting bracket holes. Drill holes into studs

or install wallboard anchors as necessary.

8. Screw in the bottom screws of the bottom bracket to anchor the bracket to the

wall. Refer to Figure 6.

Figure 6: Mounted StarInverter with Mounting Brackets in place.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Sem comentários

PV Powered PVP1800 Especificações Página 8