PV Powered PVP2000 Especificações descarregar pdf (Página 5)

PV Powered LLC 4 32-29-28-20-306

In choosing a location for the StarInverter, consideration should be given to the following

criteria:

♦ The heat sink temperatures can exceed 158 degrees (70° C). The StarInverter

must be installed so that the top of the unit will not be contacted by persons.

♦ The StarInverter is suitable for installation both indoors and outdoors and the

enclosure has been given a NEMA 3R rating.

♦ When the StarInverter is installed outdoors, it should be shielded from rain and

direct sunlight, if possible.

♦ The StarInverter is designed to handle the temperature extremes of most

climates. The operating and non-operating ambient temperature range is from

-25° C to 40° C.

♦ The following clearances are recommended for proper placement of the

StarInverter:

• A minimum 36″ clearance between the bottom of the inverter box and

the ground.

• Visibility of the operating LED’s and display located at the top front of

the inverter box should also be considered.

♦ If the inverter is to be installed in an enclosed space, adequate ventilation must

be provided.

2.2 Mounting the StarInverter

The StarInverter should be mounted vertically to a flat, solid surface such as wallboard,

concrete or wood siding. The inverter should be located in close proximity to the solar

panels to minimize the DC wire length.

The mounting bracket provided makes mounting the StarInverter quick and simple. The

two screw holes at either end of the bracket are 16 inches apart. Once the wall studs are

located, anchoring the bracket becomes an easy task.

WARNING: Prior to drilling holes to mount the StarInverter in the location

selected, ensure there are no electrical wires or plumbing in the area.

CAUTION:

The National Electrical Code (NEC) requires that the inverter be connected to a dedicated

circuit with no other outlets or devices connected to the same circuit. See NEC Section

690-64(b)(1). The NEC also places limitations on the size of the inverter and the manner

in which it is connected to the utility grid. See NEC Section 690-64(b)(2).

1 2 3 4 5 6 7 8 9 10 ... 22 23

Sem comentários

PV Powered PVP2000 Especificações Página 5