PV Powered 5200 Manual

SP-SR-V8-ENSolarRiver PV Grid-tied InverterProduct Manual SAMIL POWERExpert for PV Grid-tied InvertersTMEnglish

08Introduction ● Dimension● Weight 3.3 Dimensions and Weight Figure 6 SolarRiver 1100TL/SolarRiver 1600TLFigure 7 SolarRiver 2300TL/SolarRiver 3

ModelMax.DC power [W]Max.DC voltage [V]Max. input current [A]Number of MPP trackers/ Strings per MPP trackersMPPT voltage range (at rated powe) [V]Shu

Ground fault protectionGrid monitoringGround fault current monitoringDC injection monitoringYesYesYesYesContinued：4.4 General DataModelDimensions (W

11Installation 6 Installation 6.1 PackagingType Project No. Description QTY Remark Equipment 1 PV Grid-tied Inverter 1 unitInstallation Kit f

12InstallationSolarRiver 1100TL~1600TL Inverter Backboard SolarRiver 2300TL~5200TL Inverter BackboardWarning！Ensure that the DC side is not charged b

13InstallationStep1: Drill holes in the wall with drill machine according to the size of bracket. Drill straight into the wall do not shake the drill

14InstallationStep3Step2Step5Step4Step2: Clean all dust outside/inside the hole and ensure the distances between hole are as per requirement.Insert ex

Installation6.5 Connections of the PV power system Step3: Use the bracket to install the inverter onto the narrow vertical panel (or wall). Ensure

16InstallationNote！ Need not connect the input terminal to optimizer.● AC OutputSolarRiver series inverters are designed for single phase grid. Op

17InstallationFigure 14 AC Connector details SolarRiver 2300TL~5200TL SolarRiver 1100TL~1600TLSocket elementThread sleevewith sealing ring10-14mmsea

18InstallationStep3: Confirm that all the wires are fixed tightly( Figure 17).Step4: Fix the threaded sleeve (Figure 18).Figure 17Thread sleeveSocket

6.6 Inverter Start-up• Only start inverter after checking following• Starting invertera. Make sure all the DC and AC breakers and Isolators are i

7.2 Display FunctionThe function key is used to set the LCD. It can alternate between different parameters and languages.20OperationDisplay on norma

21Operation Normal State Pac=xxxx.xW Etotal=xx.xkwh Pac=xxxx.xW Etoday=.xxxx.xkwhPac=xxxx.xW Ipv=xx.xA Pac=xxxx.xW Vac=x

22OperationLockup function as below: Set language as below: Select language Pac=xxxx.xW Udc=xx.xV Pac=xxxx.xW Lock Pac=xxxx.x Udc=

Operation23Fault InformationOthersOutput Voltage Vac=xxx.xVOutput Frequency Freq.=xx.xHzOutput Current Iac=xx.xAPV Input Voltage Vpv= xxxVPV Input Cur

Communication and Monitoring248 Communication and Monitoring8.1 Communication Interface8.2 Communication typesSolarRiver inverters have communi

Communication and Monitoring25Figure 24 SolarLog Monitoring DiagramFigure 25 Inverter wiringFigure 26 SolarLog WiringTwo types of cable must be pre

Troubleshooting269 Troubleshooting9.1 TroubleshootingThis section contains information and procedures for solving possible problems on

Troubleshooting27Continued：Fan Fault - Check the fan for any block.- Check fan cables.- If fault persists, contact Samil Power for assistance.High DC

Copyright DeclarationThe copyright of this manual belongs to Samil Power Co., Ltd. Any corporation or individual should not plagiarize, partially copy

Decommissioning & Contacting Samil Power2810.1 Dismantling the Inverter10.2 Packaging10.3 Storage10.4 DisposalIf possible, pack the invert

Marketing & Sales OfficeAdd: No.52,Huigu Innovation Park, Huishan District, Wuxi,Jiangsu Province,P.R.China 214174Tel: +86 510

02CONTENTS1 Notes ...1.1

031 NotesDanger！Danger indicates a hazardous situation, if not avoided, will result in death or serious injury.1.1 Scope of Validity2 Safety2.

04This section gives an explanation of all the symbols shown on the inverter and on the type label.The appliance is not to be used by children or pers

05Symbol Explanation5 minDanger to life due to high voltages in the inverter!There is residual voltage in the inverter. The inverter requires

06Do not disassemble the SolarRiver Series inverter. It contains no user-serviceable parts. See warranty for instructions on obtaining service. Attemp

07Introduction ● Terminals on the inverter Caution！SF-SW. Risk of electric shock！Only authorized personnel is allowed to set the DIP switch.RS232DC