PV Powered 5200 Manual descarregar pdf (Página 16)

Installation

Step3Step2

Step5Step4

Step2: Clean all dust outside/inside the hole and ensure the distances between hole are as per requirement.

Insert expansion pipes into the holes vertically, use rubber hammer to tap the pipes into the wall completely.

Insert the bracket into expansion pipes and use expansion screws to fasten the bracket.

Step3: Mount inverter onto the narrow vertical panel, ensure upper corner of the inverter is hooked onto

the bracket, use M5 screws to fix the lower part of the inverter to the bracket (See figure 10).

Step 4: Use M5 flange nut to fix the bottom of the inverter.

Step 5: Complete the installation process.

Step1: Drill holes in the wall with drill machine according to the size of bracket. Drill straight into the wall

do not shake the drill to avoid damage to the wall. Depth of the holes should be about 30mm and should

be the same in all the holes. After removing dust from the holes, measure the net depth of the holes. If

the depth is more than 33mm or less than 27mm, the expansion pipes can not be properly installed.

Step2: Clean all dust outside/inside the hole and ensure the distances between hole are as per requirement.

Insert expansion pipes into the holes vertically, use rubber hammer to tap the pipes into the wall

completely. Insert the bracket into expansion pipes and use expansion screws to fasten the bracket.

Figure 10 Bracket Installation

● SolarRiver 1100TL~1600TL Models

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sem comentários

PV Powered 5200 Manual Página 16